How To Modify VO (Vehicle Order) with ICOM NCS Expert

This is the instruction on how to change vehicle order (VO) with NCS Expert, on BMW vehicles except F series.
VO modify tools:
ICOM A2 NCS Expert
(for BMW F series, you need ENET cable + E-sys)
steps to modify VO:
1.In NCS Expert, load the Expertmode profile.
2.Press F1 or the VIN/ZCS/FA button.
3.Press F3 or the ZCS/FA f. ECU button.
4.In the Choose CHASSIS pop-up window, choose the E89 chassis and press the OK button.
5.In the Choose ECU pop-up window, choose the CAS ECU and press the OK button.
6.The model (CHASSIS), VIN number (FG), and VO (FA) should be displayed in NCS Expert.
7.Press F2 or the Enter FA button to modify the VO.
8.In the Choose CHASSIS pop-up window, choose the E89 chassis and press the OK button.
9.In the Enter VIN pop-up window, verify that the Vin listed is the correct VIN number for the vehicle. The last digit attached to the VIN number is a checksum. You should not have to change anything on this step. Just verify and press the OK button.
10.In the Enter FA pop-up screen, for the Attribute text field, input the SA or Service Code. After typing in the code, press the Add button, and verify that the code was listed in the list of FA codes. After verifying, press the OK button.
-SA codes will begin with a “$”
-Service Codes will begin with a “+”
11.Press F6 or the Back button.
12.Press F4 or Process ECU button.
13.For the Choose ECU pop-up window, select CAS and press the OK button.
14.Press F2 or the Change job button.
15.From the Choose job pop-up window, select FA_WRITE and press the OK button.
16.Under “get coded:”, verify that CAS is the ECU selected to get coded. Also verify the JOBNAME is equal to FA_WRITE, and then press F3 or the Execute job button.
17.After the job has ended, we need to also write the new VO to the LMA ECU so that it will be both wrote to the CAS and LMA ECU. Press F1 or Change ECU button.
18.From the Choose ECU pop-up window, choose the BMW Engineer Software and press the OK button.
19.Under “get coded:”, verify that LMA is the ECU selected to get coded. Also verify the JOBNAME is equal to FA_WRITE, and then press F3 or the Execute job button.
20.After the coding has ended, you can exit out of NCS Expert.

http://obd2tools.zohosites.com/blogs/post/How-to-solve-ICOM-A2-ISTA-P-sceen-resolution-is-insufficient